Ogallala Aquifer
A. GENERAL GEOLOGY, STRATIGRAPHY, AND HYDROLOGY
The Ogallala Formation in Texas is the southernmost extension of the
major water-bearing unit underlying the physiographic province of North
America. It was named by Darton (1898) for the town of Ogallala, Nebraska,
near the type locality.
Following the Laramide revolution in which the southern Rocky Mountains
were uplifted and the Cretaceous seas retreated, rivers flowing east and
southeastward cut valleys into the pre-Ogallala surface. The deposition of
the Ogallala Formation began in late Miocene to early Pliocene age and
continued until late Pliocene time when the climate became more arid and
up-warping of the High Plains area caused deposition to cease and erosion to
begin. During Pliocene time, large quantities of eroded material from the
Rocky Mountain region were transported by wind and water southeastward and
deposited on the then existing surface of primarily Triassic and Permian age
rocks. In certain areas, the depositional surface was composed of Cretaceous
and Jurassic age sediments. The low valley areas were usually filled first
by coarser materials such as gravels and coarse sand. As the valleys and
basins filled, sediments overflowed to form coalescing aprons fed by braided
streams that spread across a generally level plain. Eventually, the entire
area was covered by Ogallala sediments until a maximum thickness of almost
900 feet (274 m) was attained in southwestern Ochiltree County (Muller and
Price, 1979; Bell and Morrison, 1978).
Throughout the time when the Ogallala sediments were being deposited, the
Southern Rocky Mountains remained tectonically active, providing source
material for the Ogallala Formation (Knowles and others 1984).
The Ogallala Formation unconformably overlies Permian, Triassic,
Jurassic, and Cretaceous strata and consists primarily of heterogeneous
sequences of coarse-grained sand and gravel in the lower part grading upward
into fine clay, silt, and sand. Gravel commonly occurs in layers in the
basal section and ranges in size from boulders to pea size. In places, the
Ogallala Formation contains some quartz gravel and caliche with pebbles and
cobbles of quartz, quartzite, and chert being common. In the Northern High
Plains the formation has been divided into three subdivisions: the
Valentine, Ash Hollow, and Kimball, based on fossil vertebrates and flora.
The subdivisions, often referred to as floral zones, are less
distinguishable in the Southern High Plains.
The sands are generally tan, yellow, or reddish brown, medium to
coarse-grained, moderately to well sorted, unconsolidated quartz grains,
interbedded with thin layers of clay and occasionally sandstone. The sand is
generally poorly consolidated to unconsolidated, although local cementation
by calcium carbonate and silica occurs. Grain size and condition of sorting
is an indication of the high energy involved in the depositional process of
these sediments. As expected, sand grain and gravel size decreases and
sorting improves eastward.
The gravel is usually associated with sand, silt, and clay and is
occasionally cemented. Quartzite is generally the predominant rock type in
the gravel, although a high percentage of limestone boulders and cobbles
occur in the southern area along with weathered Cretaceous invertebrate
fossils. The occurrence of limestone gravel and Cretaceous fossils indicate
that a local source possibly contributed to the Ogallala sediments in the
southern third of the area.
Near the surface of much of the Texas High Plains are layers of resistant
caliche known as "caprock". Caliche occurs in both Ogallala and
post-Ogallala sediments and is formed by the leaching of carbonate and
silica from surface soils and the re-deposition of the dissolved mineral
layers below the surface. Although caliche layers occur primarily near the
surface, deeper zones of caliche are also present. These deeper layers
represent older soil horizons. The caliche ranges from crumbly to very hard
and is almost impermeable although secondary porosity has been observed in
many samples.
Previously, the Ogallala was described as fluvial sediments deposited as
a series of coalescing alluvial fans or plains with only minor amounts of
eolian sediments (Seni, 1980). However, Reeves (1972), Hawley and others
(1976), and Hawley (1984) recognize the Ogallala as predominately eolian
sediments in parts of Texas and southeastern New Mexico. Outcrop and core
studies by Gustavson and Winkler (1987) indicate the Ogallala in Texas and
New Mexico consists of alluvial sediments that partly fill paleovalleys and
widespread thick eolian sediments capping paleo-uplands and most fluvial
sections. Calcic paleo-soils and fossil evidence suggest a depositional
environment in a mostly semiarid to sub-humid climate (Winkler, 1990;
Scholiast 1990; and Thomasson, 1990).
Water-bearing areas of the Ogallala Formation are hydraulically connected
except where the Canadian River has partially or totally eroded through the
formation to separate the North and South Plains. Water-bearing units of
Cretaceous and Jurassic ages combine to form the Rita Blanca aquifer in the
western part of Dallam and Hartley counties (Christian, 1983). Lower
Cretaceous units form two separate subcrops within the Texas High Plains,
the Edwards-Trinity (High Plains) and the Edwards-Trinity (Plateau).
Underlying these three aquifers and much of the Ogallala are Triassic
(Dockum aquifer) and Permian formations.
Thickness of the Ogallala Formation is primarily controlled by the
morphology of the eroded pre-Ogallala surface. The greatest thickness occurs
where sediments have filled previously eroded drainage channels. These
channels generally trend east or southeast. Other areas of large Ogallala
thickness occur in the northeast quadrant of the Texas High Plains where
sediments have filled collapsed basins formed by dissolution of Permian
evaporites.
The saturated thickness of the Ogallala Formation ranges from a few feet
to more than 525 feet (160 m). In general, the areas of greatest saturated
thickness occur in the North Plains. In the South Plains, between Lubbock
and Midland, the saturated zone varies from less than 50 feet (15 m) to 200
feet (61 m). Depth to water below the land surface can range from almost 400
feet (122 m) in parts of the North Plains to between 100 to 200 feet (30 to
61 m) throughout much of the South Plains.
Ogallala groundwater is generally fresh, containing between 300 and 1,000
milligrams per liter (mg/l) of dissolved solids of which calcium, magnesium,
and bicarbonate are the principal constituents. Some hydraulic continuity
occurs between the Ogallala Formation and the underlying Cretaceous,
Triassic, and Permian formations in many areas of the High Plains. For the
purposes of this document, the Ogallala Aquifer will be considered to
consist of the saturated sediments of the Ogallala Formation and any
underlying, potable water-bearing units hydraulically connected with it.
Post-Ogallala Depositions
Post-Ogallala sediments consist of windblown sand and silt, alluvium, and
playa lake deposits. Windblown sands occupy the largest surface area of the
High Plains of Texas and are of both Pleistocene and Recent (Holocene) age.
They are primarily fine-grained to silty, sometimes calcareous, and are
derived from lacustrine, fluvial, and eolian deposits. These sands and soils
form sheet or cover sand, dunes, and dune ridges with thicknesses generally
ranging from 0 to 10 feet (0 to 3 m).
Alluvium is present as fluvial flood plain and terraced sediments along
the more active streams and rivers. The deposits consist of poorly sorted,
often cross-bedded, gravel sand, and silt.
Lacustrine deposits, consisting primarily of clay and silt, line the
bottom of the many playa lakes on the High Plains. The sediments are
virtually impermeable, thus restricting natural recharge to the underlying
formation.
(Selected references are included in in the back of the Management Plan)
B. CURRENT VOLUME IN STORAGE:
Scope:
In the counties of Dallam, Hartley, Hutchinson, and Moore the area of
investigation was limited to that part of the counties that are within the
defined Boundaries of the North Plains Groundwater Conservation District .
Methodology:
A Water Level Elevation Map was created using winter water level
measurements measured during the winter of 1996-97. The Water Level
Elevation map was superimposed upon a Historical Base of the Aquifer
Elevation Map (Red Bed) and data points calculated at the intersections of
the contours. In areas where these intersections were scarce, values were
interpolated from the nearest redbed and contour points. From these data
points a current Saturated Material Map was created. A value of saturated
material (to the nearest 10 foot interval) was assigned from the Saturated
Material Map at the center of each section, 3/4 -,½-, and 1/4 section of
land. That value of saturated material was multiplied by the appropriate
number of acres and a storage value of .15 and the resulting values were
then totaled. Corrections were made to account for any over estimation of
area calculations.
County
|
County Area in Sq. Miles
|
County Area Calculated in District in Sq. Miles
|
Percent of County in District
|
Correction Applied to Calculations
|
| Dallam |
1494 |
741 |
49.6 |
None |
| Hansford |
907 |
917 |
100 |
.989 |
| Hartley |
1489 |
1192.75 |
80.1 |
None |
| Hutchinson |
911 |
241.5 |
26.51 |
None |
| Lipscomb |
934 |
914 |
100 |
None |
| Moore |
914 |
677.75 |
74.15 |
None |
| Ochiltree |
907 |
907 |
100 |
None |
| Sherman |
916 |
904.5 |
98.74 |
None |
Total County Area-8472 mi sq; District Area-6495
mi sq with error correction-6485 mi sq
Results:
County Acre-feet
Dallam County Water in Storage: 9,748, 800 acre-feet not a recoverable
volume
Hartley County Water in Storage: 20,175,840 acre-feet not a recoverable
volume
Hansford County Water in Storage: 18,399,207 acre-feet not a recoverable
volume
Hutchinson County Water in Storage: 4,021920 acre-feet not a recoverable
volume
Lipscomb County Water in Storage: 19,140,480 acre-feet not a recoverable
volume
Moore County Water in Storage: 11,242,320 acre-feet not a recoverable
volume
Ochiltree County Water in Storage: 16,177,440 acre-feet not a recoverable
volume
Sherman County Water in Storage: 17,749,920 acre-feet not a recoverable
volume
Total 116,655,927 acre-feet not
a recoverable volume
Omitting the bottom ten feet leaves a recoverable volume of
110,430,327 acre-feet
Average Saturated Material 187.38 Ft
C. ESTIMATED ANNUAL DECLINE (USAGE)
Scope:
In the counties of Dallam, Hartley, Hutchinson, and Moore the area of
investigation was limited to that part of the county that is within the
defined Boundaries of the North Plains Groundwater Conservation District .
In the counties of Sherman, Hansford, Ochiltree, and Lipscomb the area of
investigation includes the entire county. The area of investigation is
estimated to be 6485 square miles while the counties in their entirety are
8472 square miles. The District includes 76.55 % of the area of the
counties.
Methodology:
Water levels are measured annually between December and March in
approximately 630 observation wells located throughout the District. A
database with historical water-level measurements (630 observation wells)
was used to calculate yearly (since 1981) average decline in the water-level
of the Ogallala Aquifer throughout the District. From these, averages were
calculated for 1982 thru 1986, 1987 thru 1992, and 1993 thru 1997. The third
five-year average (1993 thru 1997) decline was selected to represent the
present decline rate.
Results:
The Ogallala Aquifer within the boundaries of the North Plains
Groundwater Conservation District is declining at an average of 1.74 feet
per year (1,082,631 acre ft). |